|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-01-2005, 01:23 PM
|
#1 | ||
|
Candy White GTI
Join Date: Jan 2005
Posts: 1,516
|
I did this quite a while ago, aswell as replacing the gear boot which in my opinion is the ugliest part of the car.
Anyone else replaced these yet?? The other day i decided to remove the gear nob and gear boot so that i could chop the gear stick down because it was just too long. I wanted to keep some of the thread so that if i ever needed to put the stocko back on i could.. but it just didnt make that much of a difference chopping so little off ( i left about 1 cm of thread). I ended up chopping around and inch and a half off in total, thus getting rid of all the threaded section. its ALOT nicer now. :P Will get pics in a couple days, If anyone else has done this post up a couple pics. Mitch |
||
|
|
|
11-01-2005, 01:46 PM
|
#2 | ||
|
Supes
Join Date: Jan 2005
Location: Sydney
Posts: 1,063
|
Tim did a similar mod to this on his focus gear shift
__________________
Yes I DO drive a Toyota |
||
|
|
|
|
11-01-2005, 02:11 PM
|
#3 | ||
|
Tricolore Tard
 
Join Date: Dec 2004
Location: Brisbane
Posts: 1,954
|
I think my knob is quite nice and not in need of replacing
 Chris
__________________
|
||
|
|
|
|
11-01-2005, 04:42 PM
|
#4 | ||
|
Fairmont Ghia
Join Date: Dec 2004
Location: NSW
Posts: 2,144
|
Yeah I did a similar thing to mine, but instead of cutting off all the thread, I bored the inside of the gearknob out so it sat lower, and can still put on the stock piece later if required.
Nice looking gearknob there tho, I like it. Tim |
||
|
|
|
|
12-01-2005, 12:28 AM
|
#5 | ||
|
Candy White GTI
Join Date: Jan 2005
Posts: 1,516
|
Too damn smart i say tim, i dont have the guts to drill my momo though :(
|
||
|
|
|
Replaced gear nob
Linear Mode
